How the checker works
Everything runs in your browser. Nothing you type is sent to us. These are the exact rules the checker applies.
The masses it works out
- Vehicle, not hitched = your weighbridge reading, or kerb mass + people + cargo + accessories.
- Caravan = your weighbridge reading, or tare + water + gas + gear + add-ons.
- Tow ball = your measured figure, or 10% of the caravan mass (or the percentage you choose) when you have not measured it.
- Vehicle, hitched = vehicle not hitched + tow ball.
- On caravan axles = caravan − tow ball.
- Combined = vehicle not hitched + caravan.
The limits it checks
| Check | Your figure | Against |
|---|---|---|
| GVM | Vehicle, hitched (or not hitched, if no caravan is entered) | Vehicle GVM |
| GCM | Combined | Vehicle GCM |
| Towing capacity | Caravan | Braked capacity; for an unbraked caravan, the lower of 750 kg and the unbraked rating |
| Towbar | Caravan | Towbar rating |
| ATM | Caravan | Caravan ATM |
| GTM | On caravan axles | Caravan GTM |
| Tow ball | Tow ball | The lower of the vehicle and towbar maximums |
A limit is close when less than 5% of it is left. The tightest limit is the one with the smallest share left. A check with missing numbers shows "need numbers": the checker never guesses a rating.
Heaviest caravan this setup can take
Once you have entered the vehicle's towing capacity, and with the vehicle loaded as you entered it and the tow ball staying at the same share of the caravan mass, the checker finds the heaviest caravan that passes every limit you gave it. Limits you have not entered are listed as not counted. It compares towing capacity, towbar rating, ATM, GTM ÷ (1 − tow ball share), tow ball limit ÷ tow ball share, GCM − vehicle mass, and (GVM − vehicle mass) ÷ tow ball share. The lowest wins.
Notes it adds
- A measured tow ball share below 5% or above 15% is flagged. Published guidance varies, with about 10% the most quoted figure, and the makers' figures come first. An estimated tow ball is not flagged, because it is only your own assumption.
- A caravan heavier than the vehicle is flagged as a rule of thumb, not a legal limit.
- If the caravan ATM is above the towing capacity or the towbar rating, it explains Queensland's guidance (allowed if the loaded caravan stays under it) and RACQ's (keep the ATM within it).
- If GCM is below GVM + towing capacity, it shows how much the vehicle may weigh when towing at full capacity.
- Brake requirements by GTM (from ADR 38 and Transport for NSW): none up to 750 kg; both wheels of at least one axle up to 2,000 kg, override brakes allowed; every wheel worked from the vehicle plus a breakaway system above that. Over 4,500 kg ATM is not a light trailer. Without a GTM the checker uses the ATM and says the result may be stricter than needed.
What it cannot tell you
- Axle loads. The vehicle's rear axle has its own limit, and a heavy tow ball can exceed it even within GVM. Weigh per axle to check it.
- Tyre load ratings, coupling ratings and the effect of a weight distribution hitch.
- Your state's paperwork, licence conditions or fines.
- Whether your plates are right. If the caravan or vehicle has been modified, its real tare may differ from the plate.
Sources
- Western Australia Department of Transport, GVM and GCM FAQs.
- Transport for NSW, Modifying trailers in NSW (trailer brake requirements).
- Queensland Government, Towing a caravan or trailer.
- South Australia, Light trailers and caravans.
- RACQ, Trailer and tow vehicle specifications.
- Federal Register of Approved Vehicles.
The calculation code is covered by automated tests, including a worked example that must match its text. Found an error? Tell us and we will correct it and note the change here.